BLACK WEIGHT POCKET 2.3 KG UNIT

High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.

WRIST DEPTH GAUGE 70 M

Wrist analog depth gauge up to 70 m, with maximum depth marker. Very useful in apnea or spearfishing lowered to control depth.

ACCESSORIES POCKET BLACK

Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.

XTREM KANGAROO SMALL HANDBAG

The TDS Xtrem Kangaroo pocket is a pocket specially designed for technical diving, being valid for both backmount and sidemount systems thanks to the versatility of its design. A pocket designed to the smallest detail to offer maximum performance to the technical diver.

2nd STAGE 90° REVOLVING CONNECTOR

Fixed elbow to place between the second stage and the hose, which allows routing to 90 degrees. Made of chrome plated brass. Thread 9/16 "Male to 9/16" female.

ON/OFF REGULATOR VALVE LONG FLOWSTOP

On / off valve that opens or closes the air flow into the hose line where it is installed. It can be installed on any standard LP regulator hose. Approximate length: 7.8 cm

ON/OFF REGULATOR VALVE SHORT

On / off valve that opens or closes the air flow into the hose line where it is installed. Ideal to place on the second stage regulator due to its small size. Approximate length: 4.5 cm

VITON O-RINGS (14 Sizes)

O-rings box Viton 85 material shore A hardness, compatible with oxygen; with 14 different sizes and 10 units of each measure. 

BACKPLATE WEIGHT POCKET 4.5 KG (Pair)

Ballast system for back plate, consisting of two pockets that are attached to a webbing and end in a riveted ring, which is attached to the holes of the back plate. The left pocket includes a D-ring for attaching a pressure gauge or monitoring device.

WRIST WET NOTE

Underwater slate, with a special shape that fits to the wrist or forearm and allows place with other instruments without any disturb.

WET NOTE CORDURE COVER

TDS slate book with 40 waterproof pages and cordura cover with small pockets. Includes graphite pen attached with bungee to one edge of the cover. Allows writing in and out of the water.

S80 STAGE TANK HARNESS

Complete harness for mounting a side tank for stage, bailout or side mount. It is valid for aluminum cylinders used in technical diving of the S80 type. The set comes pre-assembled and requires minimal installation by the user, thus customizing the position of the tank.

S40 STAGE TANK HARNESS

Complete harness for mounting a side tank for stage, bailout or side mount. It is valid for aluminum cylinders used in technical diving of the S40 type. The set comes pre-assembled and requires minimal installation by the user, thus customizing the position of the tank.

ALUMINIUM TEK GOODMAN HANDLE ADJUSTABLE

TDS Goodman type handle made of lightweight anodized aluminum. The height of the handle is adjustable by means of a side screw with a wide knob, allowing it to be adjusted to the size of our hand and/or to the use with or without gloves. It is possible to adjust the height in immersion because it is not necessary to use a wrench.

RIGHT TWIN VALVE CAP BLACK

Modular side Right-type valves cap, to close the side exit to exit manifold or modular plug. Matt black finish of the military series.

LEFT TWIN VALVE CAP BLACK

Modular side Left-type valves cap, to close the side exit to exit manifold or modular plug. Matt black finish of the military series.